Ramsey Winch HDG-350 LEVER EQUIPPED - Manual (Page 8)

6
2. Slide clutch housing #7 from end of drum shaft.
Remove setscrew #28, spring #45, and poppet
ball #18 from jaw clutch #2. Slide jaw clutch from
end of drum shaft. Remove two keys #35 from
keyways. A screwdriver can be used, at notch,
to aid in the removal of keys. Once keys have been
removed, drum #5 and thrust washer # 48 can be
removed from drum shaft.
4. See page 12 for servicing the oil cooled brake.
Remove brake housing mounting screws #25
and remove brake with gasket. Replace gasket
#33. Remove worm #16 and bearings #19 from
gear housing. Use soft hammer to gently tap
input end of worm and drive worm and bearing
from gear housing. Once worm has been
removed from housing, bearing can be pressed
from end of worm.
Check for signs of wear or damage to worm #16
and bearing #19. Replace if necessary.
3. Remove motor and coupling #3 from #1 adapter by
unscrewing two #27 capscrews with lockwasher.
Remove keys #11 from worm shaft. Unscrew four
capscrews #26 and remove adapter from gear
housing. Replace adapter seal #43 and gasket #33.
5. Remove gear housing cover #4 from gear housing #8
by unscrewing capscrews #23. Thread two of the
capscrews into the two tapped holes of cover and
tighten. This will pull the cover loose from gear
housing.
Remove cover gasket #34 and pull shaft #14, with
gear attached, and thrust washer #48 from gear
housing.