Ramsey Winch FORD SUPERDUTY GRILL GUARD AND WRAPAROUND 295955 & 295956 User Manual
Page 3
- 3 -
3. Remove tow hooks mounted on end
of frame by removing the 3 bolts
securing tow hook
(Figure 3).
4. Install left mounting bracket (Item #4) using (3
per side) 12mm bolts (Item #9) inserted through
the top of the frame rail, lockwashers (item #10),
and nuts (Item #11).
IMPORTANT NOTE: Models F-450 and F-550,
you will need to add (2) washers (Item #13)
(passenger side only) on each of the two front
holes between the mounting bracket and the
frame of the vehicle so to make the guard align
properly. (Figure 4)
Install (2 per side) ½ x 1-½” bolts (Item #12)
inserted through the side of the frame rail, washer
(Item #13) and locknuts (Item #14). (Figure #4.1)
Repeat for the right side of vehicle.
5. Reinstall bumper over mounting
brackets using factory flange nuts.
(Figure 5). Also reinstall rear support
brackets to backside of bumper.
Reinstall hood latch mechanism, engine
heater and fog lamp wiring harness.
NOTE: If installing “RE” style winch, install
winch in mounting channel at this time.
Figure 3
Figure 4.1
Figure 5
Figure 4