Ramsey Winch FORD SUPERDUTY GRILL GUARD AND WRAPAROUND 295955 & 295956 - Manual (Page 4)

- 4 -
6. Remove shipping strap and mounting bolts from winch assembly and discard. Place
frame assembly (item #1) over top of winch and secure. Use (3) 3/8-16NC x 1" lg. hx.hd.
capscrews with lockwashers and (1) 3/8-16NC x 3/4 lg. soc.hd. capscrew with high collar
lockwasher (9/16 O.D.) to attach winch to rear angle of frame assembly.
DO NOT
TIGHTEN.
Attach winch to front channel of frame assembly, using (3) 3/8-16NC x 1 lg. soc.hd.
capscrews with high collar lockwashers (9/16 O.D.) and (1) 3/8-16NC x 3/4 lg. soc.hd.
capscrew with high collar lockwasher (9/16 O.D.), as shown below.
NOTE: The (2)
outer-most capscrews are inserted through holes in face of channel and threaded into
winch. The (2) inner-most holes are placed through channel at fairlead opening and
threaded into winch.
Tighten front hardware to proper torque value then tighten
back hardware (see TORQUE VALUE CHART). Snap hole plugs (item #30) into outer-
most holes in front of frame assembly.
NOTE: The guard side plates have 2
winch channel mounting options
(Figure #8). Repeat for the right side.
Figure 6