Ramsey Winch FORD SUPERDUTY GRILL GUARD AND WRAPAROUND 295955 & 295956 - Manual (Page 7)

- 7 -
13. Place wraparound units and side plates to center unit.
Install right and left wraparound units (items #7 and #8) to
side plates of center unit using (2 per side) 3/8 x 1¼” cap
screws (item #16), (2 per side) 3/8” locknuts (item #18).
Do not tighten until later.
14. Headlight grilles are attached from the
factory to the wraparound units and side plates
of center unit using (2 per side) 3/8 x 1¼”
capscrews (item #16), (4 per side) 3/8” flat
washers (item #17), and (2 per side) 3/8”
locknuts (item #18). Far end of headlight grilles
bolt onto wraparound units. Do not tighten until
later (Figure 13).
15. If needed, install the License Plate Assembly
(item #19) to the underside of the channel (item
#1) using (2) ¼ x 1 capscrews (item #20).
16. Align and tighten all bolts to proper torque
(see chart at right).
Torque Value Chart
Bolt
Torque, Torque,
Size ft-lbs. Nm
1/4-20 9.7 13
3/8-16 39 53
7/16 58 78
½-13 87 118
12mm 60 90
17. Install the fairlead using hardware furnished
with the winch. Refer to winch owner’s manual for
complete instructions. Tighten fairlead mounting
bolts to proper torque.
18. Install the winch in the channel according to
mounting instructions in the winch owner’s
manual, using hardware furnished with winch. Do
not tighten mounting bolts until electrical
connections are complete.
19. Refer to winch owner’s manual for electrical
connections. Push battery cables into loom (item
#25) and secure using cable ties (item #24) at
each end of loom. To improve appearance, wrap
end of loom with electrical tape.
IF INSTALLING WRAPAROUND KIT #295956, FOLLOW
STEPS 13-14, OTHERWISE SKIP TO STEP 15.