Auralex SonoFlat System SFS-112 - Manual (Page 3)

SonoFlat Panel Installation Guide
➋
Apply Tubetak Pro to the back of the SonoFlat
Panel, as pictured.
➌
Carefully press SonoFlat Panel to the marked
location of the wall or ceiling. Maintain continuous
pressure. Depending on environmental and
surface conditions, it will take anywhere from
2-4 minutes to hold.
➊
Mark intended location of each SonoFlat
Panel on the wall or ceiling.
SonoColumn Installation Guide Continued
➍
Place SonoCollar around SonoColumn, if
desired. The inside section of each SonoCollar
can also be used to increase the height of the
SonoColumn by 6”.
➌
Carefully press SonoColumn to the marked
location of the wall or ceiling. Maintain continuous
pressure. Depending on environmental and
surface conditions, it will take anywhere from
2-4 minutes to hold.
TIP
For a stronger hold, with the adhesive applied, press
SonoColumn firmly into place, immediately remove it and
press it firmly again into the same spot. Or
TIP
You can use T-Pins to temporarily hold the panel in place
while the adhesive sets.