Ramsey Winch HD-P 34,9 - Manual (Page 4)

SPECIFICATIONS*
* Rope Capacity Per Layer
WARNINGS:
THE USER SHALL ENSURE THAT THE OPERATING PERSONNEL ARE GIVEN THE NECESSARY TRAINING.
THE OPERATOR SHALL ALWAYS WORK IN COMPLIANCE WITH THE OPERATING INSTRUCTIONS.
A MOTOR SPOOL (OPEN CENTER) DIRECTIONAL CONTROL VALVE IS REQUIRED FOR BRAKE OPERATION.
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF ROPE WHILE PULLING. DO NOT TRY TO GUIDE ROPE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PERSONNEL.
A MINIMUM OF 2 WRAPS OF ROPE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
IN CAR CARRIER APPLICATIONS, AFTER PULLING VEHICLE ON CARRIER, BE SURE TO SECURE VEHICLE TO
CARRIER BED. DO NOT MAINTAIN LOAD ON WINCH ROPE WHILE TRANSPORTING VEHICLE. DO NOT USE
WINCH AS A TIEDOWN.
AVOID CONDITIONS WHERE LOAD SHIFTS OR JERKS OCCUR. EXCESSIVE “INCHING” SHALL BE AVOIDED.
USER’S RESPONSIBILITY FOR CE COMPLIANCE
1.
Use only a motor spool (open center) control valve Per Hydraulic System Requirements.
2. If a remote-operated winch control valve is used, refer to Hydraulic System Requirements for Emergency Stop
components to be installed.
3. Adjust system relief pressure per Hydraulic System Requirements
4. Mount winch per Winch Mounting Instructions.
5. Install 10 mm (.393 inch), grade 1960 wire rope. For STD drum, maximum rope length of 38 M (125 ft) for four
layers maximum. For Y drum, maximum rope length of 25 M (85 ft) for four layers maximum.
Attach rope to the drum per Rope Installation Instructions. Hook must have a safety latch and a minimum breaking
strength of 87 kN.
4
First Layer Line Pull
34,9 kN (7840 lb)
Noise Level
79 db
Ambient Temp. Range -28C to 60C (-20F to 140F)
Gear Reduction 5.1:1
Weight (without rope) STD. DRUM 37.2 Kg (82lb)
"Y" DRUM 34.5 Kg (76 lb)
LAYER OF ROPE 1 2 3 4
Line pull per layer
kN 34,9 29,3 25,3 22,2
lb 7,840 6,600 5,700 5,000
STD. DRUM
m 7 16 25 38
ft 25 55 85 125
"Y" DRUM
m 4 10 16 25
ft 15 35 55 85
* Line Speed at
56,7 LPM
(15 GPM)
MPM 15,2 17,6 20,3 23,1
FPM 50 58 67 76
* These specifications are based on recommended wire rope of 10 mm (.393") 1960
grade wire rope and a 254 cc (15.5 cu in) /Rev. motor.