Rapid-Air CABINET REEL: R50, R60 & R70 SERIES - Manual (Page 3)

The main control is located behind the side access cover. Fig. Man14 is an illustration of the
layout of the control panel. This diagram lists all the components and the approximate location
of each that could be used for troubleshooting the machine if a problem should occur. The reel
can be ordered with—120 vac (1 phase) input. Terminal 4 & 5 will not be used and cannot be
used unless the Ramm is changed to a 220 volt controller. If using 220 vac 1 phase wire as in-
dicated by drawing fig. Man14. This unit cannot be used with 120 vac 1 phase input unless the
Ramm board is changed to a 120 volt controller.
2