Rapid-Air CABINET REEL: R50, R60 & R70 SERIES - Manual (Page 4)

Mechanical Operating Procedure
To Load or Unload a Coil Ring
a) If your reel has a fixed center shaft go to Step—1
b) If your reel has an adjustable center shaft go to Step—2
Step 1:
Release and remove the outer coil retainer from the shaft. Load or unload the coil ring. Re-
place and secure the outer coil retainer. The reel is now ready for production.
Step 2:
Release and remove the outer coil retainer from the shaft. If unloading, adjust the centering
arms to a position that they have released the coil. Remove the coil ring. If loading, place the
coil ring on the adjustable centering arms, adjust the centering arms until they are tight on the
coil. Replace and secure the outer coil retainer. The reel is now ready for production.
The dancer arm was designed to operate from either side of the reel. The main reason for this
was so the reel controls could be lined up on the same side as the punch controls.
To switch the dancer arm to operate on the opposite side that it is currently located on, first re-
move the counter weight it equipped with one, then turn the locking knob to disengage the lock
on the dancer arm hub. Remove the dancer arm and relocate it to the other side. Turn the hub
60 degrees and insert the dancer arm into the slot. Set to desired position. Turn the locking
knob until tight on the dancer arm. Then replace counter weight, if so equipped. The dancer
arm is now ready for production running.
3