Maple Systems HMI5000 Series - Manual (Page 13)

13 HMI5000 Series Installation Guide
1010-1005 Rev 05 www.maplesystems.com
Configuration Wiring
To configure the HMI using the EZware-5000 software, you will need
the correct configuration cable for your HMI. Please refer to the
following table for configuration (download) cable requirements.
HMI Model
Ethernet
Configuration
Cable
P/N 7431-0104
USB
Configuration
Cable
P/N 7431-0115
HMI5043N, HMI5056N, HMI5070NH,
HMI5100N
X
HMI5070TH/ETH, HMI5100T, HMI5104TH X X
HMI5043T, HMI5104XH, HMI5121X,
HMI5150X
X
Ethernet
If using a switch or router between the PC and the HMI, use a straight-
through or crossover cable as required by the switch or router.
USB
A USB driver (included with the EZware-5000 software) must be
installed when downloading from the PC to the HMI via a USB
connection. To install the USB driver, please refer to the help file ‘How
Do I’ section in EZware-5000 for detailed step-by-step instructions.
Note: When connecting two powered devices, a difference in potential can
exist between the ground reference on each device. If there is a difference in
ground potential (voltage), making a connection via a USB cable can
complete a ground loop that may damage the HMI and PC. We recommend
using the Maple Systems USB Configuration Cable (P/N 7431-0115) to
connect the HMI to the PC. The shield is not connected between the two
ends of the cable, which will prevent a potentially damaging ground loop
from occurring between the devices. Please refer to page 5 for proper wiring
instructions.