Maple Systems MAPware-7000 - Manual (Page 245)

MAPware-7000 Programming Manual 245
1010-1040, Rev. 02
Definition of Terms:

Logged Tags: this is a list of all of the tags that are to be logged for the selected Group.
To print a tag, highlight (click) the tag, then click the Add button. This will add the tag to
the ‘Tags to be Printed’ list on the right.

Tags to be Printed: this is the list of tags that will be printed. A separate column is
allocated for each tag with the option to create a heading, adjust the width of the
column, and select the number of digits (including decimal notation). To edit these
parameters, highlight each tag, adjust the parameters in the appropriate fields below,
and then click the Change button. A tag can be removed from the list by highlighting
the tag, then clicking the Remove button.

Paper Size: at the time of this printing, only A4 paper size (8.3” x 11.7”) is available.

Power Failure: This feature allows you to print a message (up to 80 characters) that
indicates a power failure. When using the Logging with Run Time Frequency mode,
during normal operation, the Data Logger will capture data according to the time
interval set in the Frequency Tag. If there are periods of time in which power is
removed from the HMC, it will not be able to capture data. To indicate periods of
power loss on the print out, you can create a message that will print instead of the
expected data.

Power Up: This feature allows you to print a brief (5 character) label indicating when
the HMC’s power was restored. This label will print just above the first data capture.

Comm Break: If some of the tags to be printed are assigned to PLC registers, this feature
allows you to print a brief (5 character) label if communications with the PLC are
temporarily lost. If such a circumstance occurs, the printout will show the last valid data
value read from the PLC register and this label.

Time Column: Use this option to display the time of each reading. Make sure that you
allocate enough characters to display the time in HH:MM:SS format.

Margin: use these settings to reserve margins on the printout.

Header: this option will print a header at the top of each page printed. Up to 4 lines (80
characters each) can be configured.

Footer: this option will print a header at the bottom of each page printed. Up to 4 lines
(80 characters each) can be configured.