Maple Systems MAPware-7000 - Manual (Page 323)

MAPware-7000 Programming Manual 323
1010-1040, Rev. 02
Touch the crosshair symbol. The symbol will then move to the upper right corner; touch it
again. Unit will calibrate and reinitialize to this screen:
For more information about this screen, see HALT mode screen below.
Entering test modes via a touchscreen button
Configure a Set Bit object on a screen in your project that is tagged to the S00038 (Factory
application menu trigger) internal memory bit. Download your application to the HMC, display
the screen, and press the button.
Mode Selection Menu
The following screen appears:
This screen is used to enter the Factory Hardware Test Mode (FHWT) or to enter the System
Setup Mode.

Factory Hardware Test Mode- these are a series of tests designed to test the hardware
functionality of the HMC. Press the FHWT button to enter this mode. For more
information on these tests, see Factory Hardware Test Mode section.