Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 8)

8
„ Attaching the Unit to a Panel
When attaching the unit to a panel other than
the Display’s main unit, attach it at the two
points identified in the diagram below. Drill
holes suitable for screws as shown in the
diagram. For attachment information, refer to
“Attaching the unit directly to the Display”.
Unit mm:[in.]
Display side settings
When connecting the RS-232C isolation unit,
the following two settings are made in the
Display's Offline mode or using the screen
creation software.
• Setting the Display's communication
method to RS-232C
• Setting the Serial Interface port's number
9 pin to VCC
In the case of the operation in the Offline
mode, change it with [Peripheral Settings] of
[Device PLC/Settings]. For the software's
operation, refer to “Device/PLC Connection
Manual”.
CE Marking
• The CA3-ISO232-01 and CA3-ISO485-
01 are a CE marked, EMC compliant
products.
These units conform to EN55011 Class A
and EN61000-6-2 directives.
Digital Electronics Corporation
8-2-52 Nanko-higashi
Suminoe-ku, Osaka 559-0031
JAPAN
TEL: +81-(0)6-6613-3116
FAX: +81-(0)6-6613-5888
http://www.pro-face.com/
© Copyright 2006 Digital Electronics
Corporation. All rights reserved.
75[2.95]
2-M3[0.12] or less
φ 9± 0.1[0.35±0.00]
0.7± 0.1[0.03±0.00]
(2.7[0.11])
φ 6.5± 0.1
3.3±
0.05[0.13±0.00]
4
+0 - 0.2
M3 SCREW
[0.16 ]
+0.00
- 0.01 [0.26±0.00]
Inquiry
If you experience difficulties or have
questions about this product, please
contact us any time.
You can access our support site
“Otasuke Pro!” whenever you need
help with a solution.
http://www.pro-face.com/otasuke/
Please be aware that Digital Electronics
Corporation shall not be held liable by the
user for any damages, losses, or third-
party claims arising from the use of this
product.
Note