Proface GP4100 - 3.4 Compact HMIs" - Manual (Page 54)

Chapter 4 Installation and Wiring
4-9
(4) Use a flat-blade screwdriver to tighten the appropriate terminal screws on the terminal connec-
tor from step 3.
• Use a flat-blade screwdriver (Size 0.4 x 2.5) to tighten the terminal screws.
The torque required to tighten these screws is 0.28N
•m (2.5 [Lb•in]).
• The power connector cannot be removed because it is mounted to GP unit. Do not
attempt to remove or tamper with the power connector. It may damage the power
connector.
• Be sure to loosen the terminal screws before pulling out the power cord. The power
connector may be damaged by pulling the power cord when attached to the power
connector.
• Do not solder the cable connection. Doing so may damage the unit due to abnormal
heat or cause a fire.
• Be sure to twist the power cords together, up to the power connector.