Proface FP3900 - 19 Flat Panel" - Manual (Page 5)

1 Part Names
A: TFT Color LCD
Displays host data.
B: Touch Panel
Switches screens or writes/sends data to the host.
C: Power Input Terminal Block
Provides power to the FP unit via the input and ground
terminals.
D: Dip Switch Cover
Covers the FP unit's operation mode dip switches.
E: Analog RGB Interface Connector
Connector for analog RGB cable.
F: DVI-D Interface Connector
Connector for DVI-D cable.
G: RS-232C Interface Connector
Connector for RS-232C (serial) cable. Used for
sending touch panel data to the host, and receiving
commands from the host.
H: USB Interface Connector
Connector for USB cable. Used for sending touch panel
data to the host, and receiving commands from the host.
I: Front LED
Used to indicate power supply, backlight or image
signal input status.
Front View
Rear View
A, B
I
Bottom View
C D E F G H
The FP-2500/FP-2600 Series unit's PDF manual file (fp2000e.pdf) is contained in the
CD-ROM's [Manual
\ Eng] folder.
Reading a PDF file requires installation of the Adobe Corporation's Acrobat ® Reader.
„ Acrobat ® Reader Installation:
To install the Acrobat ® Reader software, follow the steps given below.
1) This software, in the form of a self-extracting file, is located in this CD-ROM in the
folder titled [reader]. Use the Explorer software to find the file [Reader\Eng\
ar505enu.exe], and double-click on the file icon to begin the Reader installation.
2) After installation begins, follow the instructions given.
Acrobat ® Reader Copyright© Adobe Systems Incorporated. All rights reserved.
About The Manual