Watlow ANAWIN 3 - Manual (Page 11)

Installation AnaWin3 Quickstart Guide
8 Watlow Anafaze Doc.# 22852-10
You will also need this serial number any time you re-
quest technical support.
8. Click 
-or-
click
 to abort the program.
A message box displaying   
 will appear. Click
 to view the
  screen.
9. From the    menu on the
  screen, se-
lect

, then the Com Port used to communicate with
the PPC-2000 controller.
10. For up to 4 controllers, click  to select each controller
address.
11. Click  .
For more than 4 controllers, see the AnaWin Help file
Adding Controllers to a System for more information on
communicating with your PPC-2000.
12. Click  . If the communications test result is 


 , verify the Com Port setting, controller address, and
connections. If the communications test result displays
the firmware version for each controller, communica-
tions are setup properly.
13. From the ! menu, select
" , then  .
14. On the Windows system task bar, click

, then 
#

 , then  , then $
15. Select % from the
&  menu to verify that
AnaWin is communicating with each of the controllers.
Setting Programmable Modbus Addresses
Modbus addresses one through four may be set using the rota-
ry switch on the face of the PPC-2010 Processor Module. See
Setting Programmable Modbus Addresses on page 8 for infor-
mation on setting the rotary switch. The following procedure
describes how to set other addresses: