Watlow ANAWIN 3 - Manual (Page 6)

Doc.# 22852-10 Watlow Anafaze 3
2
Installation and Setup
This chapter describes how to install AnaWin3 on your com-
puter and how to use the configuration program to set up
AnaWin3 to communicate with your controller(s).
System Requirements
The following components are required to operate AnaWin3.
Minimum Hardware Requirements
• Pentium 200 MHz or greater with a minimum of 32 MB
of RAM (Pentium 300 with 64 MB recommended for an-
imation)
• Hard drive with 20 MB of free space (500 MB is recom-
mended for logging and trending)
• 3.5 inch HD floppy drive
• SVGA display (800 x 600 resolution, 16-bit color)
• Communications port capable of 19.2 kbaud (with 16550
UART)
• Microsoft-compatible sound card (recommended for
voice-annunciated and customized alarm sounds, but not
required)
• Microsoft-compatible pointing device (mouse or track-
ball)
Software Requirements
• U.S. version of Windows95, Windows98 or WindowsNT
4.0
• Service Pack version 4 or later for WindowsNT.