Watlow EZ-ZONE PM Express Limit - Manual (Page 17)

EZ-ZONE PM Limit Express • 17 • Keys & Displays
An active message will cause the display to toggle
between the normal settings and the active message
in the upper or left display and [Attn] in the lower
or right display.
Your response will depend on the message and the
controller settings. If the message is generated by
a latched alarm or limit condition, the message can
be silenced [Sil] or cleared [CLr] by simply
pushing the reset key when the condition no
longer exists.
[AL;L1]
Alarm 1 Low (sensor input below low
alarm set point)
[AL;h1]
Alarm 1 High (sensor input above high
alarm set point)
Alarm Error 1
[AL;E1]
Alarm 1 Error (alarm state cannot be deter-
mined due to lack of sensor input)
[Er;i1]
Error Input 1 (sensor is not providing a
valid signal to the control)
[Li;L1]
Limit Low 1 (sensor input below low limit
set point)
[Li;h1]
Limit High 1(sensor input above high limit
set point)
[Li;E1]
Li mit Error 1 (limit state cannot be deter-
mined due to lack of sensor input, limit will trip
Responding to a Displayed Message
Keys & Displays for 1/8 th
or 1/4 DIN PID Controllers
®
L
I
M
I
T
RESET
PM8
®
RESET
L
I
M
I
T
PM9
®
L
I
M
I
T
PM4