Watlow EZ-ZONE PM Integrated Controller - Manual (Page 108)

Watlow EZ-ZONE ® PM Integrated Controller • 105 • Chapter 7 Profiling Page
Configuring a Digital Input to Start and Stop a Profile
1. Navigate to the Setup Page and then the Digital I/O menu. From the Home Page, press and hold the ¿ or
Down ¯ key for approximately six seconds where the upper display will show [``ai] and the lower dis-
play will show [`set].
2. Press the Up ¿ or Down ¯ key to navigate to the Digital I/O menu. Upper display will show [`dio] and
the lower display will show [`set].
3. Press the Advance Key ‰ where the first available digital instance will be displayed in the upper display.
4. Press the Up ¿ or Down ¯ key to select the input of choice.
5. Press the Advance Key
‰ to select the direction (input or output). In this example, select Dry Contact
[iCon]
.
6. Select the level (high or low) that will activate the function by pressing the Advance Key ‰ where the up-
per display will show [high] and the lower display will show [`leu].
7. Press the Up ¿ or Down ¯ keys to select the level that will start the profile (high = closed or low = open).
8. Press the Advance Key
‰ to select the function. In this example, select Profile Start / Stop [p ;sts].
9. Press the Advance Key ‰ to select the function instance (Profile to start).
10. Return to the Home Page by pressing and holding the Infinity Key ˆ for approximately three seconds.
Starting a Profile from the Operations Page
1. Navigate to the Operations Page and then the Profile Status menu. From the Home Page, press and hold
the ¿ or Down ¯ key for approximately three seconds where the upper display will show [``ai] and the
lower display will show [oper].
2. Press the Up ¿ or Down ¯ key to navigate to the Profile Status [p ;sta] menu.
3. Press the Advance Key
‰ to enter this menu. The upper display will show [```1] and the lower display
will show [p ;str].
4. Press the Up ¿ or Down ¯ keys to select the Profile or Step to start. In this example select 1.
5. Press the Advance Key
‰ to select the Profile Action Request. The upper display will show [none] and
the lower display will show [p ;aCr].
6. Press the Up ¿ or Down ¯ keys to select the Profile start. The upper display will show [Prof] and the
lower display will show [p ;aCr].
Note:
As soon as the Green Advance key is pressed (step 7 below) the designated Profile or Step (as determined in
step 4 above) will start.
7. Press the Advance Key ‰ to select whether Event 1 will be on or off. The upper display will show [`off]
and the lower display will show [ent1].
Note:
This setting will temporally override the profile configuration.
8. Press the Up ¿ or Down ¯ keys to select whether Event 1 will be on or off. This will immediately drive
the Event to the specified state regardless of the Profile configuration.
9. Press the Advance Key ‰ to select whether Event 2 will be on or off. The upper display will show [`off]
and the lower display will show [ent2].
10. Press the Up ¿ or Down ¯ keys to select whether Event 2 will be on or off. This will immediately drive
the Event to the specified state regardless of the Profile configuration.
11. Press the Advance Key ‰ to see the current Jump Count. The upper display will show [```0] and the
lower display will show [``jC].
11. Return to the Home Page by pressing and holding the Infinity Key ˆ for approximately three seconds.