Watlow EZ-ZONE RMA Modul - Manual (Page 8)

Watlow EZ-ZONE ® RMA Module • 5 • Chapter 1 Overview
Module Orientation
The picture below reflects a front view of an RMA module. Like all RM modules, there are four slots that
appear on the face (slot A, B, D, and E) of the module and one on the bottom (slot C) not shown. For this
particular module only slots D and E can be used. On the face of the module there is a button (orange circle)
under the Zone address [J] that when pushed and held has the following function:
1.Push and hold for ~ 2 seconds to change the Zone address. Valid addresses range from 1 -17 ([1] - [9], [a] is
10, [b] is 11, [C] is 12, [d] is 13, [e] is 14, [f] is 15, and [h] is 16). The Access module is shipped (default fac-
tory address) at address [j] or 17
SD Card
USB, Mini Type B
connector
Module Status (Slot A, B, D,
or E not used on this module)
Backplane Protocol (For this
module always set to Stan-
dard Bus -red)
Output indicators (1 to 16)
not used on this module.