Watlow Silver Series Addendum - Manual (Page 18)

Silver Series OIT  18  Watlow Addendum
5) For Address choose 4x
and enter the address
of the Closed Loop
Working/Active Set
Point for your
controller. See the
table.
6) Click the Numeric
Format tab.
7) In Data format set the
data type. See the
table.
8) On the Font tab set
Align to Right.
(013)
For this
controller… This
parameter… Enter this
Address*… Choose this
Data Type…
RMCxxxx-xxxxxxx
Closed Loop
Working/Active
Set Point
(Read Only)
2513 32-bit Float
RMHx-xxxx-x1xx 5233 32-bit Float
PMxxxxx-xxxxxxx 2173 32-bit Float
STxx-xxMx-xxxx 204 32-bit Float
ST via RUI Gateway 2173 32-bit Float
Other Controllers Consult the controller manual.
*These addresses have already been changed to the absolute form required
for EasyBuilder5000 by adding 1 to the value listed in the Watlow manual.
Enter them as listed.
9) Click OK.
10) Move the cursor with
the outline to position
the display field and
click to place it.
11) Adjust the size of the
field as needed.
12) From the File menu
choose Save.
(014)