Watlow SpecView from Watlow User Manual
Specview from watlow, Hmi software, Addendum to specview manual
Advertising
Table of contents
Document Outline
- Cover
- Contents
- Chapter 1: Introduction
- Chapter 2:
About Setting up Communications
- Protocol Drivers
- Automatic and Manual Configuration
- Naming Instruments
- Saving Settings in Non-Volatile Memory
- Using EZ-ZONE Controllers with Standard Bus
- Using EZ-ZONE Controllers with Modbus
- SpecView Instruments Supporting EZ-ZONE Devices via Modbus
- SpecView Address Strings for EZ-ZONE Devices via Modbus
- Controller or Gateway’s Address
- Decimal Places
- Register Address Offset
- Gateway Offset
- Register Addresses and Offsets for...
- Address String Example 1: Analog Input 1 in an EZ-ZONE ST via Modbus RTU
- Address String Example 2: Analog Input 2 in an EZ-ZONE ST via Modbus RTU
- Address String Example 3: EZ-ZONE PM Controllers via an EZ-ZONE RUI Gateway with Modbus TCP
- EZ-ZONE Modbus Profile Instruments
- Old EZ-ZONE Modbus Instruments
- Chapter 3: Setup Procedures
- Chapter 4: Feature Reference
- How to Reach Us