Wright Serial # 55138 and higher - Manual (Page 19)

19
4.5 Deck Lift Lever
The “Quick Cut” height selector will adjust the cut height in ¼” increments.
To operate, ensure the cutter deck is in the full up and locked position,
insert detent pin in desired cut height hole, grab deck lift handle and pull
back to unlock the deck lift locking mechanism. Lower to the selected cut
height.
4.6 Safety Interlock System
The Wright Stander ZK is equipped with a safety interlock system. The PTO must be disengaged, brake
applied and control levers in the neutral position in order to start the machine. With the brake applied, the
controls are locked in the neutral position.
Deck Lift Handle, full
up and locked position
Detent Pin
Parking brake applied, locks control levers
Parking brake
safety switch
Parking brake Off, levers free to move