Wright Serial #55142 and higher - Manual (Page 5)

3
Move the engine throttle control to ¾ RPM speed setting.
Turn on the blade clutch switch. Run blades for approximately one minute. Next, engage and disengage the
blades a few times about 10 seconds apart. If the blades do not start and stop in a few seconds each time,
service the blade brake system.
With the blades on, disengage the OPC switch to test the Operator Presence Control switch (OPC). A time
delay has been added to the OPC system. The engine should die and the blades should stop with-in 4-7
seconds after leaving the seated position. If not, service the OPC system.
Disengage the blades.
Drive the mower around on a level parking lot. Check that the mower drives in a straight line when both hand
controls are at the full speed position. (If not, refer to How to Perform The Tracking Adjustment section of this
manual) (The control handles may not line up perfectly)
As you drive the mower, listen for any unusual noises and test for irregular operation and adjust or service
as necessary.
Go over the safety information and operating procedures in this manual with the customer. Instruct each
customer in proper operation and observe the customer during their initial operation on a level parking lot.
Repeat until the customer is familiar and comfortable with the basic operation and use of the mower.
•
Dealer:
Register the mower online within 14 days from the date of retail purchase.
(If unable to use the online registration process, contact your Distributor to
register for you)
Registering the product indicates you have successfully completed the pre-delivery
service checklist.
The limited warranty is considered invalid unless the unit is registered and the above
steps are taken.
Remember, the purchaser is both your customer and our customer and his/her
satisfaction is very important. Thank you for supporting our products.
The mower is now ready for delivery to your customer