Ybravo BRAVO 25 Mower 25-201 - Kawasaki - Manual (Page 8)

8
ASSEMBLY - SETUP
STEP 6
To assist with the installation of the drive cable to the lower
control bar push the control bar past the spring lock (1) that
normally retains the control bar in a comfortable operating
position.
STEP 7 Honda Engine
Fill the engine with a SAE 10W-30 engine oil.
Fill; 22 Fl.Oz (0.7 Qt. - 0.65Liters)
Please read the Honda engine Owner’s Manual for full
information.
UPPER LIMIT
LOWER LIMIT
OIL FILLER CAP/DIPSTICK
Insert the end of the spring into the hole (2) in the control bar.
- Pull back on the cable adjustment knob and insert into the
slot of the control panel.
- For initial set-up turn the drive cable adjustment (3) all the
way counter clockwise. For correct adjustment see page 11.
- Pull up on the control bar to check the function.
1
2
Insert the barrel shaped cable fi tting into the hole on the
plastic arm (1).
Pull down on the cable sheath (2) and insert into the hole in
the control panel (3)
STEP 5
Install the blade brake clutch cable into the plastic arm on the
control panel as illustrated.
1
2
3
3
STEP 4
Insert the throttle cable inside the left handle tube. Install the
cable into the throttle control. Adjust the cable to the middle
position of the threaded stud and tighten the 10mm nuts.
Adjust the cable to a
middle position
Follow the separate instructions for Honda and Kawasaki to
verify that the throttle control is adjusted properly.
See Page 9.
STEP 7 Kawasaki Engine
Fill a new engine with an SAE 10W-30 engine oil.
Fill; 22 Fl.Oz (0.7 Qt. - 0.65 Liters)
If the oil fi lter is changed the fi ll volume is;
29 Fl.Oz (0.9 Qt - 0.85 Liters)
Please read the Kawasaki engine Owner’s Manual for full
information.