Yokogawa HART Communicator YHC5150X - Manual (Page 15)

15
2.4.5. Dialog for Required DD File List
After the conversion process, the following dialog may be displayed.
Figure 2-8 Dialog for required DD file list
To display converted DTM data in the HART Built-in DTM, the DD file of the target device
configuration file is required.
Therefore, the conversion process is skipped for the device type or device revision for which the
corresponding DD file has not been installed in FieldMate and the dialog is displayed with a list of
required DD files.
If this dialog is displayed, exit the Data Converter and install the required DD files in the FieldMate
(for details, see Chapter 3).
Then, start the Data Converter again, convert the target device configuration files into DTM data,
and save it.