010 sec, Sealwater : yes – Yokogawa Pneumatic Retractables RF20H User Manual

Page 14

Advertising
background image

IM 12B06K07-E-E

If you want to change times, select the desired time
by means of the soft keys and confirm with Enter.
The following display is shown:

Time Setup Clean I/1

10…300 Sec

010 Sec

UP

DOWN

The first line shows the admissible time range, the
next line shows the currently set value.

You can change this value by means of the soft
keys. Keep a soft key pressed for 2 seconds, then
the value starts changing automatically. By pressing
the Enter button, you save the changed value.

By pressing the ESC button, you leave the menu
without saving!

Proceed correspondingly for the remaining
times! For the detailed description of the
function please refer to chapter 3.

Real Time Event
In the Real Time Event the defined starting times for
a rinsing process are set. The following display is
shown:

Real Time Event

Event No.1

00:00

Event No.2

00:00

Event No.3

00:00

Event No.4

00:00

Event No.5

00:00

UP

DOWN

i

The defined times for 5 starting times are shown.
By means of the i button you get access to further
starting times (max. 15).

If you want to change the times, select the desired
point in time by means of the soft keys and confirm
with Enter. The following display is shown:

Real Time Event

00 : 00

UP

DOWN

NEXT

The first line shows the currently set starting time.
You can change this value by pressing the soft
keys. Keep one soft key pressed for 2 seconds and
then, the value starts changing automatically.
By pressing the NEXT button, you switch between
hours and minutes and vice versa.
By pressing the Enter button, you save the changed
value.

By pressing the ESC button, you leave the menu
without saving!

Please proceed correspondingly for the
remaining points in time! For a detailed
description of the function, please refer to
chapter 3.

Seal water
In the menu point Seal water you can switch the
seal water function on and off.
Upon selection the following display is shown:

Seal water

Sealwater : YES

YES

NO

Switch the seal water function on (YES) or off (NO)
by means of the two soft keys.
By confirming with the Enter button, you save the
changed value.
By pressing the ESC button, you leave the menu
without saving!

Operation Mode
In the menu point Operation Mode you can set the
mode of operation of the control.
Upon selection the following display is shown:

Operation Mode

Real Time Event
External Trigger

g

Loop

Event + Trigger
Loop + Trigger

UP

DOWN

The arrow shows you the currently set mode of
operation.
You can change the mode of operation by pressing
the soft keys.
By confirming with the Enter button, you save the
changed mode of operation.
By pressing the ESC button, you leave the menu
without saving!

CAUTION!

DANGER!

WARNING!

CAUTION!

DANGER!

WARNING!

Advertising