Yokogawa Pneumatic Retractables RF20H - Manual (Page 15)

IM 12B06K07-E-E
6.5 System
In the menu point System you can parameterize the
system settings.
Upon selecting System in the main menu, you must
enter the pass code:
Input System Code
0 0 0 0
UP DOWN NEXT
Enter the pass code by setting the digits via the UP
and DOWN buttons and skip to the right by means
of the NEXT button.
As soon as the pass code has been entered
completely and correctly, confirm with Enter and
you reach the menu of the system menu. The
following display is shown:
System Menu
Set Clock
Set Date
Test OUT / IN
Change Code
UP DOWN
Select the desired function by means of the soft
keys and confirm with Enter.
Set Clock
In the system mode Set Clock, the time can be set.
The following display is shown:
Set Clock
12 : 15 : 45
HH : MM : SS
UP DOWN NEXT
You can change the time by pressing the soft keys.
Keep a soft key pressed for 2 seconds and the
value starts changing automatically. By pressing the
NEXT button, you switch from hours to minutes and
seconds and back.
By confirming with Enter, you save the changed value.
By pressing the ESC button, you leave the menu
without saving!
Set Date
In the system mode Set Date, the date can be set.
The following display is shown:
Set Date
31 . 03 . 08
DD : MM : YY
UP DOWN NEXT
You can change the date by means of the soft
keys. Keep a soft key pressed for 2 seconds and
the value starts changing automatically. By pressing
the NEXT button you can switch from day to month
and to year and back.
By confirming with Enter, you save the changed
value.
By pressing the ESC button, you leave the menu
without saving!
Test OUT / IN
In the system mode Test OUT / IN, you can test the
inputs and the outputs of the control.
The following display is shown:
Test OUT / IN
Channal : 1 2 3 4 5 6 7
OUT : 0 0 0 0 0 0 0
I
IN : 0 1 0 0
ON OFF g
Select the channel via the g button. The marking
shows you the channel you have selected. By
pressing the soft keys ON and OFF, you switch the
outputs on (1) or off (0). The IN line shows you the
current status of the inputs.
By pressing ESC you leave the menu and the
outputs are reset again.