Yokogawa Standalone MW100 - Manual (Page 14)

14
IM CA150E
When using RSLogix 500 ® with controllers such as the MicroLogix ® series that have on board Ethernet support, the Setup Screen
looks slightly different instead of a Node Address, direct input of the MW100 IP address is allowed (no gateway or DF1 to EIP
routing is required in this case).
Write Message as confi gured in a MicroLogix ® or SLC 505 ® with EIP support
An explicit message should be triggered on/off by some sort of logic; the following image represents using the seconds bit of the
PLC’s clock to activate the message.
Time Based Message Write