Connecting to the ethernet interface, Inserting and ejecting the cf card – Yokogawa PC-Based MX100 User Manual
Page 11
11
IM MX100-72E
7. Connecting to the Ethernet Interface
Connect the Ethernet cable to the Ethernet port of the main
module. Use a UTP cable (category 5 or better) or an STP cable for
the Ethernet cable.
RJ-45 modular jack
Ethernet port
Ethernet cable
• Checking the Communication Status
You can check the status on the two LEDs at the upper-right
and lower-right of the Ethernet port.
ETHERNET
10BASE - T
100BASE - TX
LINK LED
Illuminates in orange when the link between
the MX100/MW100 and the connected device
is established and communication is mutually
possible.
ACT LED
Blinks green when transmitting/receiving
packets.
Inserting and Ejecting the CF Card
• Inserting the CF Card
To insert the CF card into the card slot, open the slot cover and
face the card's front side to the right.
• Ejecting the CF Card
Be sure to check that the CF card is not being access before
ejecting the card from the slot. When the CF card is being
accessed, the 7-segment LED indicates that processing is taking
place.
For the MX100, to eject the CF card, open the slot cover while
touching the metal for discharging the static electricity, press the
access stop switch, and press the eject lever once. Then, press
the eject lever that came out once again, and remove the CF
card from the slot.
Slot cover
Front side of the
CF card
Card slot
Access stop switch
Metal for discharging
the static electricity
Eject lever
Slot cover
For the MW100, be sure to check that the CF card is not being
accessed before ejecting the card from the slot. To eject the CF
card, first open the slot cover while touching the anti-static metal,
then push the eject lever once. Next, push the eject lever (which
is pulled out) again, and pull out the CF card.
Metal for discharging
the static electricity
Eject lever
Slot cover
Reverse side
of the CF card
Note
Do not close the slot cover by force while the
eject lever is pulled out. Doing so can damage
the card slot. When not using the eject lever,
push the lever in so that the slot cover can
close.