Yokogawa PC-Based MX100 User Manual

User’s manual, Warning, Attachment procedure

Advertising
background image

User’s

Manual

Yokogawa Electric Corporation

IM MX100-74E

6th Edition

WARNING

• To prevent electric shock and instrument breakdown, do not connect the power

supply to the main module when attaching modules.

Attachment Procedure

1. Check that the power supply is not connected to the main module.
2. Align the connector on the rear panel of the module to the connector at the desired

position of the base plate and insert the connector.

When the connectors are correctly connected, the guide pin on the rear panel of the

module is inserted into the guide hole on the base plate. In addition, the module is
secured to the base plate with the latch lever locking in place at the bottom section of
the base plate.

3. Fasten the attachment screws (M3) at the top of the module.

To remove the module, loosen the attachment screw, pull down on the latch lever on the
rear panel of the module, and pull the module straight from the base plate.

*1

Base plate connector cover

*1

(accessory sold separately)

Input/Output module

Module attachment screw

Module connector

*2

Screw holes

Guide holes

MX100

Main module

Base plate

Base plate

Latch lever

(Pull up to remove the module

from the base plate.)

Guide pins

MW100

Main module

Screw holes

Guide holes

Module connector

*2

Base plate

Base plate connector cover

*1

(accessory sold separately)

Input/Output module

Module attachment screw

Base plate

Latch lever

(Pull up to remove the module

from the base plate.)

Guide pins

MX100 Main module

MW100 Main module

Can be attached by hooking the top section of the cover to the top edge of the base plate and pressing down on the lower section of the

cover

When attaching the module, be sure that the module

connector is vertical to the base plate so that the

module connector pins are not bent.

*2

Note

• Attach the main module to the right-most position on the base plate.
• The 30-CH, Medium Speed DCV/TC/DI Input Module takes up three modules worth of

space when attaching to the base plate. If attached incorrectly, damage or malfunction can
result.

• The 10-CH, Pulse Input Module is compatible with the MW100.

6th Edition: September 2013 (YK)
All Rights Reserved, Copyright © 2013 Yokogawa Electric Corporation

MX100/MW100

Handling of the Input/Output Modules

Advertising
This manual is related to the following products: