Contract or – Thermolec AcuSteam User Manual
Page 21
Page 19
CONTRACT
OR
15.
Installing the Humidifi er
For ease of service, keep a minimum space of 24” in front of the unit.
15.1
Remove both covers by fi rst turning the 1/4 turn screw to the left and swing open the tank cover and
unhook it. Then unscrew the two screws holding the electrical cover and pull it towards you.
15.2
Remove the white wire connected on the water pan at the bottom of the unit. This is the overfl ow
sensor.
15.3
Remove the overfl ow pan by lifting the front off its holding screw and pull towards you. Do not remove
those screws from the humidifi er middle wall.
15.4 The
humidifi er must be installed on a vertical fl at surface (i.e. wall or vertical furnace duct). Because of
the length of the steam hose supplied, select the location of the unit as close as possible within a maximum
of 4 feet of the diffuser.
Please see Fig. 15.a for necessary clearances around the humidifi er.
WARNING: Never install the humidifi er directly on the furnace cabinet as this could void your furnace warranty.
12”
6”
3”
12”
Fig. 15a
!
A
CU STEAM