Ameriphone IIIP TTY - Manual (Page 12)

1. Turn on TTY.
2. Hold down , press 0 and
will be displayed on the
screen.
3. Type in the phone number.
4. If you make a mistake in typing, press
to delete one space at a
time until the mistake is deleted.
5. After all numbers are entered, press
to start the dialing sequence.
If a dial tone is not detected,
will appear on the
screen (in some countries where the dial
tone may be different than the U.S., you
can override the waiting sequence by
pressing again).
6. If the line is busy, will be dis-
played and the SIGNAL indicator blinks
quickly. Hold down and press to
hang up.
7. If the other party answers by TTY, you'll
see a greeting message on the screen.
Proceed with your conversation.
8. If the party answers by voice, the SIG-
NAL indicator light will flicker. Turn the
TTY voice announcer on by holding down
and pressing the .
9. Printing Auto Answer Messages
CHAPTER 5
(CONTINUED) CHAPTER 6
OPERATING YOUR TTY
A. Making a Phone Call (Direct Connect)
1. Hold down press 7 .
2. Press repeatedly until
appears.
3. Press N (for No) to turn off this feature.
4. Hold down and to
return to normal TTY operation.
AUTO I.D. ON? Y/N
2. Manual Dialing from Keyboard:
ENTER PHONE NO
8
DIALOGUE III-P TTY is set up to print and
record all incoming call messages. However,
you may turn off print function to save paper.
1. Hold down and press 7 .
2. Press seven times until
PRINT MESSAGES? Y/N appears.
3. Press N to turn off printing.
4. Hold down and press
to return to normal TTY operation.
8. Relay Voice Announcer for Auto Answer
You can add the Relay Number Voice Announcer
to your outgoing message. When your TTY an-
swers an incoming call, it will activate the Relay
Number Voice Announcer first and then follow
with the Auto Answer Message.
1. To turn on this feature, hold down and
press
7 .
2. Press four times until
VOICE ANSWER ON? Y/N appears.
3. Press Y to select the feature.
4. Hold down and press to
return to normal TTY operation.
All DIALOGUE TTYs are equipped with an Automat-
ic TTY Call Identifier feature which automatically
sends out an audible identification tone every six
seconds when your call is answered by a voice. It
notifies a hearing person that this is a TTY call, and
it triggers automatic TTY detection equipment used
in public dispatching facilities. The signal indicator
blinks when the audible tone comes on and the tone
automatically stops when either party starts to type.
1. Turning Off Audible Identification Tone:
(Optional)
WAIT FOR DIAL TONE
BUSY
10