MAHLE RTI BFX-2 - Manual (Page 4)

Page 3
System Priming (First Time Use Only)
Note: System Priming is only necessary before the first time use of the BFX.
Connect red (positive) clamp on power cable to red (positive) terminal on vehicle battery. Connect
the black (negative) clamp to a good ground. A good ground can be located by following the negative
cable from the battery to where it is connected to the chassis.
Warning: Handle battery connection cable with extreme caution. Batteries generate
explosive gases during normal operation. Working in the vicinity of a lead-acid or
other automotive battery is dangerous. Wear eye protection. Never smoke or allow
a spark or flame in the vicinity of the battery. Do not connect the black power clip
to the negative post of the battery to avoid a spark.
R T I T E C H N O L O G I E S
B F X - 2 V
N E W T A N K = # # O Z
S E L E C T P R O C E S S
N E W T A N K E M P T Y
S C A N N E W B O T T L E
I N S T A L L B O T T L E
P R E S S > C O N T I N U E <
³ This will display for five seconds.
Buzzer will beep once. All LED’s will blink on
briefly.
³ This will display.
Connect Fill Gun to Fill Hose.
Disconnect coupler on Used Fluid Tank and
remove cap.
Press FILL MASTER CYLINDER.
Buzzer will beep three times.
³ This will display.
Swipe bar code on new bottle of Valvoline
Brake Fluid. Each bottle can only be scanned
once (the BFX records the bar code number
and will prevent a second scan). Buzzer will
beep once when valid bar code is read by
scanner.
³ This will display.
Install New Fluid Float Switch in bottle of brake
fluid.
Press CONTINUE.