MAHLE RTI BFX-2 - Manual (Page 5)

Page 4
R E M A I N I N G = # # O Z
F I L L I N G M C
N E W T A N K = # # O Z
S E L E C T P R O C E S S
³ This will display.
Place nozzle of Fill Gun into the Used Fluid
tank and squeeze trigger.
Remaining ounces will be displayed and when
zero will stop the process.
Press FILL MASTER CYLINDER to stop the
process.
Release trigger. Replace cap on Used Fluid
Tank and connect coupler.
³ This will display.
Exchange Brake Fluid
BEFORE SERVICE: Verify that the brake system does not have any malfunctions. If the system is
found to be malfunctioning verify that the malfunction will not interfere with the
exchange process. Perform all necessary repairs prior to fluid exchange.
Connect red (positive) clamp on power cable to red (positive) terminal on vehicle battery. Connect
the black (negative) clamp to a good ground. A good ground can be located by following the negative
cable from the battery to where it is connected to the chassis.
Warning: Handle battery connection cable with extreme caution. Batteries generate
explosive gases during normal operation. Working in the vicinity of a lead-acid or
other automotive battery is dangerous. Wear eye protection. Never smoke or allow
a spark or flame in the vicinity of the battery. Do not connect the black power clip
to the negative post of the battery to avoid a spark.
R T I T E C H N O L O G I E S
B F X - 2 V
³ This will display for five seconds.
Buzzer will beep once. All LED’s will blink on
briefly.