PreSonus StudioLive 24.4.2 - Manual (Page 17)

13
3 Hookup
3.1 Rear-Panel Connections
StudioLive™ 24.4.2/16.4.2
Owner’s Manual
S/PDIF Output. By default, the S/PDIF output receives the same signal as the main
outputs, so no activation is necessary. However, any bus can be routed to the S/PDIF
output, either through the System menu in the Digital Effects | Master Control
section, or in VSL. (See Section 5.4 in this manual or Section 3.7.1 in the StudioLive
Software Library Manual for more information.) Because the StudioLive cannot be
synced externally, you will need to use it as the master clock and set your S/PDIF-
equipped device to receive word clock externally via S/PDIF. Please consult the
documentation for your external digital device for instructions.
2 Amp Fuse. This is the StudioLive’s fuse housing. The StudioLive uses a 5 mm x 20
mm, 250 VAC, fast-acting fuse.
Power-adapter Input. This is where you plug in the provided IEC power
cable.
Power Switch. Push the top part of the switch ( | ) to turn on your StudioLive. Push
the bottom part of the switch ( O ) to turn it off.