PreSonus StudioLive 24.4.2 - Manual (Page 58)

54
4 Controls
4.7 Master Section
StudioLive™ 24.4.2/16.4.2
Owner’s Manual
4.7.2 Talkback System
The StudioLive features a Talkback microphone input on the back panel. This
can be routed to the aux outputs and to the mains. It is important to note
that the aux outputs are grouped in this section. For example, if you are using
Aux 1 as a mono monitor send to the bass player’s floor wedge and Aux 2 as
the monitor send to the keyboard player, the talkback signal will be sent to
both monitors—so don’t say anything you wouldn’t want both to hear!
Power User Tip (StudioLive 24.4.2 only): While the talkback microphone is
patched to aux outputs in groups, you do have independent level control over
this input in each of the 10 aux mixes by using Aux Flip Mode. Because of this,
you can adjust the talkback signal up or down or even off on a per-aux basis.
For more information about Aux Flip Mode, please see Section 4.4.3.
Talkback Mic Level. Controls the Overall Level of the Talkback Mic.
This knob controls the overall volume of the external Talkback input. The trim for
the Talkback mic is located on the back panel next to the input. See Section 3.1 for
details.
Output Selector Buttons. Assigns the Talkback Mic to the Aux and/or Main Outs.
These buttons assign the talkback mic to a specified output. These buttons are
toggled on/off and will illuminate indicating that the Talkback output is active. The
talkback mic can be assigned to every output at the same time.
Talkback Button. Turns the Talkback Mic On/Off.
This latching button turns the talkback mic on and off. It will illuminate
to indicate that the talkback mic is active. When illuminated, the
talkback-mic signal will be patched to all assigned outputs.
4.7.3 2 Track In
The 2 Track input allows you to patch in an analog input or a playback stream
from your audio application. This enables you to compare audio sources
during mixdown or patch in intermission music between bands without using
any of your input channels. This is a summing bus, so both the external tape
input and the two-track FireWire return can be engaged at the same time.
2 Track In Volume Control. Adjusts the Level for the Tape Input.
This knob adjusts the level for both the tape input and the main FireWire return.
Tape Input On/Off Button. Patches the Tape Input to the Main Outputs.
This button patches the Tape input to the main outputs. It will
illuminate to indicate that the Tape input is being sent to the mains.
To disable the routing, simply press the button again.
FireWire Source On/Off Button. Patches the Main FireWire Return to the
Main Outputs.