3 speaker connection, 1 configuring connector and owner plates, 2 rs15 connectors – Nexo RS User Manual

Page 16

Advertising
background image

Page 16/58

RS15

G

ENERAL

I

NSTRUCTIONS

2.3 Speaker

connection

2.3.1 Configuring Connector and Owner plates

Owner and Connector plates can be exchanged depending on chosen directional configuration

Please note that the connector plate can pass through the holes, no unsoldering is therefore required.

• Directional Mode : it is recommended to install the connector panel on the side which supports

the rigging plates;

• Omni Mode: it is recommended to install the connector panel on the side opposite to the drivers

(factory default configuration)

CONNECTOR PLATE IN DIRECTIONAL MODE

CONNECTOR PLATE IN OMNI MODE

2.3.2 RS15

connectors

RS15 is connected through Speakon NL4FC plugs (not supplied). A wiring diagram is printed on the
connection panel located on the back of each cabinet.

The 4 pins of the 2 Speakon sockets are connected in parallel within the enclosure.

Either connector can be used to connect an amplifier or to link to an additional RS15 cabinet.

Connectors are wired as follows:

Speakon NL4F

Connectors

Omni Mode

Directional Mode

Comment

1(-)

15’’ driver Right (-)

15’’ driver Rear (-)

1(+)

15’’ driver Right (+)

15’’ driver Rear (+)

Driver Next to Connector

Panel

2(-)

15’’ driver Left (-)

15’’ driver Front (-)

2(+)

15’’ driver Left (+)

15’’ driver Front (+)

Driver Opposite to

Connector Panel

Advertising
This manual is related to the following products: