ReadyLIFT Ford F250 Super Duty SST Lift Kit: 2005-2007, 4WD Only - 2.5/2.0"R" - Manual (Page 4)

ReadyLift® (Part# 69-2517CP & 69-2518CP) Installation Instructions
2005-UP Ford F-250 Super Duty 4WD w/Camper Package
ReadyLift®
2060 Placentia Ave Suite B-1, Costa Mesa, CA 92627
T o l l F r e e ( 8 0 0 ) 5 4 9 - 4 6 2 0 L o ca l ( 9 4 9 ) 5 1 5 - 0 7 9 5 F a x ( 9 4 9 )5 1 5 -0 6 5 5
Please read instructions thoroughly and completely before beginning installation.
Installation by a trained mechanic is highly recommended.
6.
Remove the two 19mm bolts on the factory
track bar bracket (one on each side of the
track bar mount). Remove the three 21mm
nuts located on the cross member. Remove
track bar bracket. Install ReadyLift® track
bar bracket using the factory hardware.
Torque to factory specs. Reference torque
specs on front page.
Driver side Passenger side
OEM Hole
OEM Hole
7.
2005-2007 Models - Reinstall brake line
support brackets.
2008 models drill 3/8” hole approximately
2” below the factory hole, use the factory
self-tapping screw to re-attach the brake
line support bracket.
Track Bar
Using factory hardware re-install track bar
onto the new ReadyLift® track bar bracket.
Re-install sway bar end links.
Torque to factory specs. Reference torque
specs on front page.
Remove OEM front bump stops.
Remove the 10mm bolts that attach the
bump stop brackets to the frame.
Install ReadyLift® bump stop extension
bracket. Using a Phillips screw driver, in-
sert it into the holes in the extension and
use the handle as a leverage point to
tighten.
Install OEM bump stop bracket using nut
provided. Install OEM bump stop.
8.
9.