ReadyLIFT Ford F250 Super Duty SST Lift Kit: 2005-2007, 4WD Only - 2.5/2.0"R" - Manual (Page 5)

ReadyLift® (Part# 69-2517CP & 69-2518CP) Installation Instructions
2005-UP Ford F-250 Super Duty 4WD w/Camper Package
ReadyLift®
2060 Placentia Ave Suite B-1, Costa Mesa, CA 92627
T o l l F r e e ( 8 0 0 ) 5 4 9 - 4 6 2 0 L o ca l ( 9 4 9 ) 5 1 5 - 0 7 9 5 F a x ( 9 4 9 )5 1 5 -0 6 5 5
Please read instructions thoroughly and completely before beginning installation.
Installation by a trained mechanic is highly recommended.
10.
Be sure to double check that all hardware has been tightened and torqued to
factory specs.
Remount wheels and tires and torque to factory specs. Re-torque wheels after
25 miles.
*
See next page for Tire/wheel fitment specifications.
Wheel Alignment; a Certified Alignment Technician that is experienced with
lifted vehicles is recommended to perform the alignment.
*It is recommended that you have your vehicle’s alignment checked whenever
installing new tires.
*It is also recommended that you adjust your headlights whenever your vehicle’s
ride height is altered.
Warning! This ReadyLift® Leveling Kit is designed and engineered to level out a
stock vehicle with no prior modifications. The use of this kit along with items
such as suspension lifts , body lifts or any other type of lifting accessory shall
be done at the vehicles owners risk and will void any and all warranties in effect
or implied by ReadyLift®. This kit is not for off road abuse.
Carrier Bearing Spacer Installation
Remove the two 15mm bolts, use a
jack stand to support the drive shaft.
Install the ReadyLift® carrier bearing
spacer using the hardware provided.
Torque to factory spec. Reference
torque specs on front page.
Rear Block Installation
Remove the four 24mm nuts on one
side. Remove the U-bolts. Using a jack,
carefully raise the truck by the leaf
spring until OEM block is loose and
there is enough room the for new
block. Install ReadyLift® 4” rear block.
Please note that the arrow on the bot-
tom of the block points to the front of
the truck. Install ReadyLift® U-bolts
using the hardware provided. Torque
to factory specs. Repeat on opposite
side
.