Acer Altos G5350 Series - Manual (Page 117)

107
To set a Supervisor/User password
1 Use the up/down keys to highlight a password parameter
(Supervisor Password or User Password) then press Enter.
A password box will appear.
2 Type a password then press Enter.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3 Retype the password to verify the first entry then press Enter
again.
After setting the password, the system automatically sets the
chosen password parameter to Installed.
To change the Supervisor/User password
1 Use the up/down keys to highlight either change password
parameters (Change Supervisor Password or Change User
Password) then press Enter.
2 Type the original password then press Enter.
3 Type a new password then press Enter.
4 Retype the password to verify the first entry then press Enter
again.
To remove the User password
1 Use the up/down keys to highlight the Clear User Password
parameter then press Enter.
Password on
boot Select Enabled to activate security
check during POST. Disabled
Enabled
Fixed disk
boot sector Sets the control level of the hard disk
drive. Normal
Write Protect
Diskette access Sets the control level of the floppy
drive. Supervisor
Normal
Parameter Description Option