ReadyLIFT GMC Sierra 1500 2WD Long Travel Front Suspension Kit - 2007-2013 User Manual
Page 2
www.ReadyLIFT.com
Phone (702)410-2300
Pre installation notes and preparations:
The following are necessary in order to complete the installation and pro-
vide adequate provisions for intended off-road use. Take extra precaution
and necessary safety procedures when making any and all modifications
to vehicles being fitted with aftermarket components. Prior to installation
of these components, completely and thoroughly read all the installation
procedures and make sure you are able to safely complete all the steps
and recommendations. For technical assistance or questions regarding
ReadyLIFT Off-Road Series kits:
1-800-549-4620
Required modifications for safe and proper fitment of ReadyLIFT Off-Road
Series increased travel suspension system(s):
Front track width widened by 2.5” per side
Aftermarket widened front fenders (OE inner liners will not be used)
Requires removal of OE suspension limiter at frame (cutting required)
Wheels with proper backspacing (Min. 4.5” backspacing required)
Properly sized tire fitment (35in. OD recommended)
Modified or aftermarket front bumper
Modified wheel well openings and firewall area near foot-wells
Relocating parts in/around wheel well areas
Note:
OE wheel well liners will not be reused and sheet metal cutting
is required along with removal of OE front fenders and washer fluid
reservoir (optional).
Note: (Rear only)
Cutting of the rear fender wells/bed required to
complete installation of bed cage.
Rear leaf pack requires removal of fuel tank and or exhaust system
(near leaf spring front hanger) to remove/install OE hardware
Bed cage install w/hydraulic bump stop requires removal of OE bump
stop from frame.
Installation Instructions (49-3004)