Unit location and clearances – Mammoth 3/4 to 5 Tons: Single Circuit Horizontal and Vertical (U-Vintage) User Manual

Page 5

Advertising
background image

5

MAMM-WSHP-IOM-1UB (September 2011)


Unit Location and Clearances

The diagrams below show minimum suggested clear-
ances. Any additional clearances would be beneficial,
but not always necessary. The requirements on any
specific unit may increase or be reduced depending on
several factors such as maintenance requirements and
mechanical or electrical installation codes. If return air
is not ducted, enough clearance will be required to pro-
vide for adequate airflow.

Horizontal units have three access panels; one panel
for the blower, one for the electrical panel and one for
the compressor compartment. Horizontal unit filters are
removed from the right or left side with an option for
bottom removal.

Vertical units need to be accessed on three sides; two
panels for the compressor and blower, one for the elec-
trical panel and compressor compartment. Vertical unit
filters are removed from the right or left side.

Horizontal unit clearances

Vertical unit clearances

Advertising