Brocade VDX 8770-8 Hardware Reference Manual - Manual (Page 89)

Brocade VDX 8770-8 Hardware Reference Manual 69
53-1002564-04
Management module removal and replacement
5
3. Rotate both ejectors simultaneously toward the center of the module.
4. Pull the management module out of the chassis by the ejectors.
FIGURE 21 Removal and replacement of the management module
Replacing a management module
For this procedure, refer to “ESD precautions” and Figure 21 .
Complete the following steps to insert an MM.
1. Unpack the new MM and remove it from the anti-static bag.
2. Inspect the module for damage.
3. Remove the protective caps from the backplane connectors.
4. Rotate the ejectors toward the center of the module.
5. Align the module pan with the guides in the slot. The first MM should be installed in slot M1.
6. Slide the MM into the slot until it is firmly seated.
7. Rotate the ejectors away from the center of the module face until the module is tight in the slot.
8. Tighten the captive screws using the Phillips screwdriver.