Brocade Universal Four Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 10)

10 of 20 Universal Four-Post Rack Kit Installation Procedure
53-1002944-01 Rev.B
Attaching the rear brackets to the extensions
Complete the following steps to attach the rear brackets to the extensions. There are short, medium and long rear
brackets you can use for this step. Choose the correct bracket for the depth of your rack.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension, as shown in Figure 5 .
The short rear brackets are shown. Use the first and third vertical pairs of holes for the screws.
Refer to Figure 6 for the positioning of the medium or long brackets and screws.
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left extension.
5. Adjust the brackets to the rack depth and tighten all the 6-32 x 1/4-in. screws to a torque of 9 in-lbs (10 cm-kgs).
FIGURE 5 Attaching the rear brackets to the extensions
1 Brackets, rear 2 Screws, 6-32 x 1/4-in., panhead Phillips