Brocade Universal Four Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 17)

Universal Four-Post Rack Kit Installation Procedure 17 of 20
53-1002944-01 Rev.B
Attaching the rear brackets to the extensions at the front of the switch
Complete the following steps to attach the rear brackets to the extensions. There are short, medium and long front
brackets you can use for this step. Choose the correct bracket for the depth of your rack.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension, as shown in Figure 11 .
The short rear brackets are shown. Use the first and third vertical pairs of holes for the screws.
Refer to Figure 12 for the positioning of the medium or long brackets and screws.
3. Attach the brackets using four 6-32 x 1/4-in. screws.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left extension.
5. Adjust the brackets to the rack depth and tighten all the 6-32 x 1/4-in. screws to a torque of 9 in-lbs (10 cm-kgs).
FIGURE 11 Attaching the rear brackets to the extensions at the front of the switch
1 Brackets, rear, short 2 Screws, 6-32 x 1/4-in., panhead Phillips