Brocade Multi-Service IronWare Security Configuration Guide (Supporting R05.6.00) - Manual (Page 130)

112 Multi-Service IronWare Security Configuration Guide
53-1003035-02
Configuring numbered and named ACLs
3
Filtering traffic with ICMP packets
Use the following parameters if you want to filter traffic that contains ICMP packets. These
parameters apply only if you specified icmp as the ip-protocol value.
icmp-type Enter one of the following values, depending on the software version the
Brocade device is running:
• any-icmp-type
• echo
• echo-reply
• information-request
• mask-reply
• mask-request
• parameter-problem
• redirect
NOTE: The redirect parameter is not supported on the Brocade NetIron CES or Brocade
NetIron CER devices.
• source-quench
• time-exceeded
NOTE: The time-exceeded parameter is not supported on Brocade NetIron CES or Brocade
NetIron CER devices.
• timestamp-reply
• timestamp-request
• unreachable
• num
NOTE
If the ACL is for the inbound traffic direction on a virtual routing interface,
you also can specify a subset of ports within the VLAN containing that
interface when assigning an ACL to the interface. Refer to
“Configuring
numbered and named ACLs” .