Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 23)

Multi-Service IronWare QoS and Traffic Management Configuration Guide 9
53-1003037-02
Traffic policing on Brocade NetIron CES and Brocade NetIron CER devices
1
NOTE
Port based rate limit counters are not supported for Brocade NetIron CER and Brocade NetIron CES.
Resetting the rate limit counters
You can reset all of the rate limit counters using the following command.
Brocade# clear rate-limit counters
Syntax: clear rate-limit counters slot/port
The slot/port variable specifies a port for which you want to clear the rate limit counters. If you do
not specify a port, all rate limit counters on the device are reset.
Displaying rate limit policies for a specific interface
To display information about rate limit policies that are configured for a specific interface, enter the
following command at the interface level.
Brocade(config-if-e10000-1/1)#show rate-limit
Syntax: show rate-limit
Output such as the following is displayed.
interface e 1/1
rate-limit input 959904 2000000
rate-limit output 2986368 2000000
This display shows the following information.
Displaying rate limit policies configured in policy maps
To display information about rate limit policy maps, enter the following command.
Brocade(config-policymap)#show policy-map pmap1
Syntax: show policy-map name
The name variable limits the display to the map specified. If this variable is not used, configuration
information is displayed for all policy maps configured on the device.
Re-mark The number of packets for which priority has been remarked as a result of exceeding
the bandwidth available in the CIR bucket for this rate limit policy.
Total Total traffic (in bytes) that has been carried on this interface for the defined rate limit
policy since the device was started or the counter was reset.
TABLE 3 Rate limit interface parameters
This field... Displays...
rate-limit input The average-rate and maximum burst rate configured for inbound traffic on the
specified interface.
rate-limit output The average-rate and maximum burst rate configured for outbound traffic on
the specified interface.
TABLE 2 Rate limit counters parameters (Continued)
This field... Displays...