Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 29)

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 19
53-1003029-02
Hardware features
1
10 Gigabit Ethernet ports
A 10 Gigabit Ethernet module contains two or four physical ports, through which you can connect
your device to other network devices at a speed of 10 Gigabits.
Into a physical port, you must insert a fiber-optic transceiver provided by device. The
XFP/SFP+-compliant fiber-optic modules provide an optical transceiver or physical
medium-dependent (PMD) interface for single or multi-mode fiber that can be used with the LAN
physical layer (PHY).
The following 10 Gigabit optics are available from device.
Port regions
Ports on the devices are grouped into regions. For a few features, such as port monitoring and
unknown unicast configurations, you will need to know the region to which a port belongs. However,
for most features, a port’s region does not affect configuration or operation of the feature. If a
port’s region does affect configuration or operation of a feature, it is noted and described in the
appropriate feature section of this guide.
Brocade NetIron CES 2000 Series 2024 and CER 2024 devices with 24 ports have 2 optional
10-GbE ports:
E1MG-100FX 100Base-FX SFP optic multi-mode fiber, LC connector
E1MG-100BXU 100Base-BXU SFP optic single-mode fiber, 1310nm, LC connector.
This optic can only be connected to an E1MG-100BXD.
E1MG-100BXD 100Base-BXD SFP optic single-mode fiber, 1490nm, LC connector.
This optic can only be connected to an E1MG-100BXU.
E1MG-100FX-IR 100BaseFX-IR optic for SMF with LC connector. For distances up to 15nm.
E1MG-100FX-LR 100BaseFX-LR SFP optic for SMF with LC connector. For distances up to 40km.
TABLE 6 MSA-compliant Optics for the 10 GbE Ethernet interface module
Part number Description
Devices with up to two 10GbE ports (XFP)
10G-XFP-SR 850nm serial pluggable XFP optic, target range 300m over multi-mode fiber
10G-XFP-LR 1310nm serial pluggable XFP optic for up to 10km over single-mode fiber
10G-XFP-ER 1550nm serial pluggable XFP optic for up to 40km over single-mode fiber
10G-XFP-ZR 1550nm serial pluggable XFP optic for up to 80km over single-mode fiber
10G-XFP-ZRD 10GBase-ZR DWDM, XFP optic, 80km, 1530.33 to 1561.42
10G-XFP-CX4 10-Base-CX4, XFP transceiver, 15km, CX connector
Devices with up to four 10GbE ports (SFP+)
10G-SFPlus-SR
10G-SFPlus-LR
10G-SFPlus-ZR
10G-SFPlus-ZRD
TABLE 5 SFP-compliant transceivers for the 100/1000 Ethernet interface module (Continued)
Part number Description