Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 55)

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 45
53-1003029-02
Device installation
3
FIGURE 44 Installing the Brocade device in a rack
I
Installation steps
1. Mount the device in the rack as illustrated in Figure 44 .
2. Using a 2-hole grounding lug and a minimum #6 AWG grounding wire, ground the chassis to
either a common bonding network or an isolated bonding network.
3. Proceed to “System power” on page 46.
You will need the following tools for installation:
• #2 Phillips-head screwdriver
• Four #10-24 screws (or as specified by rack type) to mount the device to the rack