Assembling the wire saddle for the eps cord – Brocade ICX 6450 Stackable Switches Hardware Installation Guide User Manual
Page 58
1
Rack-mounting screws
2
Cage nuts
FIGURE 45 Installing the external power supply in a rack
5.
If installing multiple external power supplies, mount them in the rack one below the other.
Assembling the wire saddle for the EPS cord
The wire saddle for the EPS cord is used to hold the EPS cord securely in place when connecting to
multiple devices. This is an optional installation that will help to prevent the EPS cord from accidentally
unplugging and losing connection with the external power receptacle. Assemble the wire saddle on
both ends of the EPS cord.
Complete the following steps to assemble the wire saddle for the EPS cord.
1.
Using a Phillips screwdriver, remove the two screws on the EPS faceplate of the external power
receptacle, as illustrated in the figure below.
Assembling the wire saddle for the EPS cord
56
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
53-1003079-01